У меня есть маршрутизатор AT-AR725. Настройки сбросил
Его надо настроить в роли PPPoE клиента, для раздачи интернета. На eth0 будет подаваться wan кабель, eth1 будет подключен к свичу
Есть имя и пароль (PPPoE)
Не нашёл информацию как настроить
sh sys
- Код: Выделить всё
Manager > sh sys
Router System Status Time 07:10:48 Date 08-Nov-2018.
Board ID Bay Board Name Rev Serial number
--------------------------------------------------------------------------------
Base 181 AT-AR725 M2-0 58245604
--------------------------------------------------------------------------------
Memory - DRAM :131072 kB FLASH : 16384 kB
--------------------------------------------------------------------------------
SysDescription
Allied Telesyn AT-AR725 version 2.5.1-00 11-Dec-2002
SysContact
SysLocation
SysName
SysDistName
SysUpTime
13999194 ( 1 days, 14:53:11 )
Boot Image : 745_107.fbr size 894264 21-May-2003
Software Version: 2.5.1-00 11-Dec-2002
Release Version : 2.5.1-00 13-Dec-2002
Patch Installed : NONE
Territory : europe
Help File : 700-251b.hlp
Main PSU : On Main Fan : On
RPS Monitor : Off
Configuration
Boot configuration file: boot.cfg (exists)
Current configuration: boot.cfg
Security Mode : Disabled
Patch files
Name Device Size Version
--------------------------------------------
52251-02.paz flash 117552 2.5-2
--------------------------------------------
sh rel
- Код: Выделить всё
Manager > sh rel
Release Licence Period
-------------------------------------------------------------------
flash:load\52-251.rez full -
-------------------------------------------------------------------
sh feat
- Код: Выделить всё
Manager > sh feat
The Special Feature Licences:
Index FeatureName Licence Period
-------------------------------------------------------------------
1 factory full -
-------------------------------------------------------------------
The current valid features :
Secure Shell
ISAKMP
PKI
sh ip
- Код: Выделить всё
Manager > sh ip
IP Module Configuration
------------------------------------------------------------------------------
Module Status .................. ENABLED
IP Packet Forwarding ........... ENABLED
IP Echo Reply .................. ENABLED
Debugging ...................... DISABLED
IP Fragment Offset Filtering ... ENABLED
Default Name Servers
Primary Name Server .......... Not Set
Secondary Name Server ........ Not Set
Source-Routed Packets .......... Discarded
Remote IP address assignment ... DISABLED
DNS Relay ...................... DISABLED
Routing Protocols
RIP Neighbours ................. 0
EGP Status ..................... DISABLED
Autonomous System Number ....... Not Set
Transfer RIP to EGP ............ Disabled
ARP aging timer multiplier...... 4 (1024-2048 secs)
OSPF Status .................... DISABLED
IGMP Status .................... DISABLED
DVMRP Status ................... DISABLED
PIM Status ..................... DISABLED
IP Multicast HW switching ...... DISABLED
BGP Status ..................... DISABLED
Active Routes
Static ......................... 0
Interface ...................... 1
RIP ............................ 0
EGP ............................ 0
OSPF ........................... 0
Other .......................... 0
Multicast ...................... 0
IP Filter Configuration
Total filters .................. 0
Dynamic Interfaces ............. 0